Laboratory glassware main use and the matters needing attention

Laboratory glassware main use and the matters needing attention

Name The main purpose Precautions for Use
Beaker To prepare solutions, dissolve samples, etc When heating, should be placed on asbestos net, make its be heated evenly, cannot burn dry commonly
Conical flask The sample was heated and titrated by volumetric analysis In addition to the same requirements as above, the plug should be opened for the grinding cone when heating, and the original plug should be kept for the non-standard grinding
Flat bottom flask Heat and distill liquids Generally avoid direct fire heating, asbestos mesh or various heating bath heating
Round bottom distillation flask Distillation; It can also be used as a small amount of gas generation reactor Same as above
Measuring cylinder, measuring cup To measure roughly a given volume of liquid Do not heat it, do not prepare the solution in it, do not bake it in an oven, do not operate by adding or pouring the solution along the wall
Volumetric flask Prepare a standard solution or solution to be tested in an exact volume Non-standard grinding plug should be kept original; Water leakage can not be used; Can not be baked in the oven, can not be heated by direct fire, can be heated by water bath
Burette (25,50,100 ml) Volumetric analysis titration operation; Acid form, base form Piston should be original; Water leakage can not be used; Can not be heated; Can’t store lye for a long time; The base tube shall not discharge titrant acted on eraser
Microburette 1, 2, 34, 5, 10ml Micro or semi micro analytical titration operation Only piston type; Other precautions are the same as above
Automatic burette Automatic titration; Can be used for titrating liquid to isolate air operation In addition to the same requirements as the general burette, pay attention to the storage set, in addition, to be equipped with a double ball for air
pipette Remove an exact amount of liquid Can not be heated; Do not break the top and tip
Graduated pipette Accurately remove various amounts of liquid Same as above
Weighing bottle Dwarf used for measuring drying weight loss or drying reference materials in the oven; High shape is used for weighing reference materials and samples Do not cover the grinding plug tightly baked, grinding plug to the original
Reagent bottle: small mouth bottle, wide mouth bottle, lower mouth bottle Thin-mouthed bottles for storing liquid reagents; Wide mouth bottles for solid reagents; Brown bottles are used to store reagents that decompose easily when exposed to light Can not be heated; Do not prepare a solution in a bottle that emits a lot of heat during operation; Grinding plug should be kept original; The bottle of lye should use rubber stopper, lest it cannot be opened for a long time
Dropping bottle Pack reagents to be dripped Same as above
Funnel Long neck funnel for quantitative analysis, filter precipitation; A short-necked funnel is used for general filtration Same as above
Separating funnel: drop spherical pear-shaped tube Separate two insoluble liquids; For extraction separation and enrichment (mostly pear shaped); Adding liquid to preparation reaction (mostly spherical and drip funnel) Grinding cock must be original, leaky funnel can not be used.
Test tube: ordinary test tube, centrifugal test tube Qualitative analysis to test ions; Centrifuge tube can separate solution and precipitate by centrifugation in centrifuge The tube made of hard glass can be heated directly on the flame, but can not gather cold; Centrifugal tubes can only be heated by water bath
Condensing tube: straight, spherical, serpentine air condensing tube Used for cooling distilled liquid, serpentine tube is suitable for condensing low boiling point liquid steam, air condensing tube is used for condensing boiling point above 150℃ liquid steam Can not gather cold gather heat; Pay attention to the cooling water from the lower mouth and the water from the upper mouth
Filtering flask Filtrate is accepted during extraction Belongs to the thick wall container, can withstand negative pressure; Do not heat
Watch glass Cover beaker and funnel etc Do not heat directly, diameter should be slightly larger than the covered container
Mortar Grinding solid reagents and samples; Do not grind substances that interact with glass Can’t hit; Can’t bake
Desiccator Keep dried or burned materials dry; Small amounts of prepared products can also be dried Put color-changing silica gel or other desiccant at the bottom, cover the grinding mouth coated with appropriate vaseline; Do not put red hot objects, put hot objects always open the lid to avoid the lid jump or cooling can not open the lid
Vertical melting glass funnel Filter Must be pumped; Can not gather cold gather heat; Can not filter hydrofluoric acid, alkali, etc.; Wash immediately after use
Standard grinding mouth combination instrument Preparation and separation in organic chemistry and organic semi-trace analysis Grinding mouth do not need to be coated with lubricant; Installation can not be subjected to skewed pressure; Purchase all necessary equipment

Post time: Oct-15-2021